FICTIONAL CROSS-PORTED BODY — ESTIMATING DIMENSION SCHEDULE REV A
Units: inches; block3.000 x2.000 x1.500, raw1.750 plate. General+/-0.005.
Coordinates: x along3, y along2, z along1.5; origin lower near-left corner.
Top bore: dia0.750, x1.500/y1.000, from z1.500 to z0.500.
Side passage: dia0.375, x1.500/z0.750, from y0 to y1.000.
End passage: dia0.375, y1.000/z0.750, from x0 to x1.500.
Three setups. Same fixture priced in316 and360 brass, not approved substitutes.
Thread/seat detail absent:20 setup+6 run min allowance. Clean15+4 min.
Test budget30 setup+5 run min plus$150/lot; no approved pressure/medium/time/
leakage acceptance, test procedure, valve internals, plugs, seals or test report.
Not a pressure-rated design or manufacturing release; engineering approval required.